slow clap
Face did well.
Nope
1 Like
I’m lovin’ it™
Glad that thing is staying in the tarckfam.
wait. where can i get the FRI decal? I want my bike to say friendpoint too
Yikes! Glad you’re not dead and your bike is going to a good home. That coffee setup looks legit. 
Cut up another ENDPOINT decal.
1 Like
took me a minute to try and figure out where the R is in endpoint… except that’s a P with the bit of cut off E tacked on
Bottom of the N. The bottom of the E was used to patch it into an F.
Who here has a small HG that can do a quick stand over height measurement?
Gimme a sec… 77cm from floor to toptube (at the middle of toptube) on 54-584.
1 Like
This is 6 days late, but thanks for the quick reply from Prison Island.
Also FYI everyone out there with Day Ruiners, yes the H/G can fit 2.25’s* with a front pusher. Ran TB’s in 2.25 with a front mech/nerd cranks 44/28 on a shake down overnighter, no problems, feels like I could even squeeze a 2.3 or 2.35 tyre in there.
*depending on size of side knobs
On that note, my friend bought a h/g and his rear seatstay bridge almost touches the tires on 2.2s, whereas I have the exact same tires and I have like 1.5cm clearance.
Sup with that?
What tires?
Different sized frames or same size?
1 Like
WTB bee-line 27.5x2.2"
Both are L.
Mine is gen2, his is gen3, which may have something to do with it.
FWIW, he loves it, but it stacks mud with the bee-lines. He’s gonna switch to gravelkings.